Doosan DH215 DH220 DH225 中型バックホーのための油圧ディストリビュータ

DH215 DH220 DH225 Control Valve Assy for Doosan Excavator spare parts Hydraulic Control Valve Aftermarket

Product Overview

Machines of this generation have an advantage that newer ones lost: everything can be diagnosed with gauges. There is no controller deciding how flow is distributed, no sensor reporting pressure to a screen, no software layer between the lever and the cylinder. On a DH215, DH220 or DH225, hydraulic behaviour is set mechanically inside the control valve, which means a competent mechanic can isolate a fault with a pressure gauge and a flow meter rather than a laptop — and can confirm whether the block is the cause before spending money.

This hydraulic control valve divides pump flow among boom, arm, bucket, swing, travel and auxiliary across the three designations. When spools and bores wear, the symptoms are measurable rather than mysterious: the boom sags on a held bucket, the arm loses force under resistance, swing lands short, travel bogs under load. This aftermarket assembly replaces the block complete with fresh internals set to working values, so the worn unit comes off and the replacement fits the original port positions.

Core Advantages

1. Verifiable with gauges, not guesswork
On a mechanically controlled machine, pressure and flow tests prove whether the block is at fault before any money is spent.

2. Repairable by local workshops
No special tooling or software is needed to fit the assembly, which matters in markets where dealer support is thin.

3. Force returns at the cutting edge
Renewed spools put pressure back into the arm and bucket, so the machine digs rather than labouring.

4. Loads hold through the truck cycle
A sagging boom forces a re‑spot every pass. Restored retention keeps the bucket where it was placed.

5. Complete assembly across three designations
We confirm the configuration from your tag and serial, so one order covers the platform without approximation.

Manufacturing & Quality Control

Spool and bore pairs are machined to print tolerance, matched by size, and hand‑run‑in until full‑stroke movement is free of binding. Assembled blocks are flow‑tested circuit by circuit with relief values logged against platform figures; out‑of‑window units are stripped and corrected. Blocks ship internally oil‑fogged, ports capped, and crated on foam.

Frequently Asked Questions

Q1: Does one block cover all three designations?
A: They share a platform but differ in trim and some porting. Send the tag from the existing valve plus the serial plate and we confirm the match.

Q2: How can a mechanic prove the valve is at fault?
A: Measure main relief and circuit pressures against specification, then check for drift on a held load. Flow falling short under load points to internal leakage.

Q3: What symptoms indicate valve wear?
A: Boom drift on held loads, lost arm force under resistance, inconsistent swing, and travel that reacts to bucket load.

Q4: Can my existing block be rebuilt?
A: If the casting is sound and has never been rebuilt, a kit may restore it. Where several circuits leak, a complete assembly usually gives better service per dollar. Photos help us judge.

Q5: What hydraulic servicing accompanies installation?
A: Flush the system, renew filters, clean the suction strainer, refill with specified oil, and verify relief settings afterwards.

Q6: What is excluded from warranty?
A: Material and assembly faults are covered. Damage from dirty oil, water ingress, a spool forced against a bind, or reliefs altered outside specification is not. Photograph the crate before opening if damage is visible.