sheet width 3050 mm
plate thickness 6.5 mm
thickness at "Niro-steel" 4.0 mm
back stop - adjustable 750 mm
work height max. 770 mm
no. of strokes 11 - 22 Hub/min
Control SC 5
cutting angle 0.5 - 3.0 °
down holder 18 Stück
voltage 380 V
engine output 11.0 kW
weight of the machine ca. 5000 kg
range L-W-H 3950 x 1750 x 1720 mm
** well-maintained condition (!!)

Equipment:
- electro-hydraulic / slide-guided guillotine shears
- HACO NC control model SC 5, front left
* pre-selected positioning of the back stop
* digital display of actual position
* electro-hydraulic cutting angle adjustment
* electro-hydraulic cutting gap adjustment
* programmable retraction from the back stop
* emergency stop switch
- electro-motor-driven back stop, on ball screws
- hydraulically acting sheet metal hold-down device
- front finger guard
- 1x extra long side stop, with mm scale + support foot
- 2x front support arms
- 1x freely movable foot switch
- rear protective device
- operating instructions in German (PDF)

* special accessories included:
- HACO sheet metal holding device for thin sheet metal cuts
- HACO replacement blades (1x set)
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.